Syringe Holder/Loader

[jacb]

Has anyone tried the syringe holder/loader available on Etsy? Listing

As we all know when using a 29g or similar needle, cypionate takes some time to draw. Here is a device that you can start drawing and come back to in five minutes.

I would like to know if it will work with a BD 29g x 1/2” x 0.30 mL syringe. It seems to say that it will work with either 1 mL or 10 mL vials.

I have no financial interest in the sale of this item.

 

[jacb]

Anyone?
The online seller won’t sell to NZ!

 

[ignition]

I used a generic small water bottle for loading an insulin syringe to load my daily dose. The opening size of the bottle was perfect, allowing the syringe to hang inside, with the vial not fitting through/falling in. The rubber stopper provides enough friction to hold the syringe in place, the crimped metal vial top sat inside the rim and the glass sat on the rim perfectly.

 

[excelnelg]

Who on TRT therapeutic levels of testosterone is taking an amount that needs to draw for five minutes?

 

[jacb]

Who on TRT therapeutic levels of testosterone is taking an amount that needs to draw for five minutes?

It’s a turn of phrase, don’t be quite so literal.

It still takes a while to load a syringe and just like the person who made the holder, seen above, I would like to set it filling and brush my teeth etc rather than waste the time waiting (“a watched kettle never boils”)….. but I can’t get the guy to sell me one in NZ and I don’t know if it would fit my BD 29g x 12mm x 0.3 mL syringes?

 

[jacb]

I used a generic small water bottle for loading an insulin syringe to load my daily dose. The opening size of the bottle was perfect, allowing the syringe to hang inside, with the vial not fitting through/falling in. The rubber stopper provides enough friction to hold the syringe in place, the crimped metal vial top sat inside the rim and the glass sat on the rim perfectly.

That’s a little hard to picture … can you post a photo?

 

[ignition]

That’s a little hard to picture … can you post a photo?

 

[jacb]

OK I get it ….. I would just need to get some form of tube and cut a longitudinal slot in it to keek the syringe drawing. I think the stand in my link may be the best way to go. I will try and get one via some sort of postage forwarding service and find out if it fits my BD syringe type.
Thanks anyway.

 

[Cataceous]

Another simple option, a piece of stiff wire bent to hold the vial and hang it from something. A wood chip, syringe cap, etc. holds the plunger out: