ExcelMale
Menu
Home
What's new
Latest activity
Forums
New posts
Search forums
What's new
New posts
Latest activity
Videos
Lab Tests
Doctor Finder
Buy Books
About Us
Men’s Health Coaching
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
Testosterone Replacement, Low T, HCG, & Beyond
Testosterone Basics & Questions
Injecting Testosterone and HCG in same syringe
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Re-Ride" data-source="post: 65278" data-attributes="member: 8395"><p>3 cc pre-fitted with a short needle are common. Uptake the hCG, remove and discard the needle, draw the plunger back so you have 1cc or better air space then set in a vial luer lok side up. Use your insulin needle to draw your AAS and top load it in the 3 cc. Inject with needle of choice, preferable 27G or 25G. The hCG acts as a flush limiting injection loss of the AAS. </p><p></p><p> Injecting with a luer lok needle finer than a 27 is certainly possible but requires excessive plunger pressure. Most doing this prefer deep IM to SQ. There are good reasons not to mix oil and water based injectables including the possible formation of white goo at temps below about 70F and concern about what may happen inside the muscle. </p><p></p><p>One thing to note is how much AAS you are actually drawing and transferring to the injection syringe as there will be nothing left in the drawing syringe if you purge it with air. Use a 0.5 short insulin syringe to draw AAS. Pull the plunger down and measure what you've drawn between the 0.2 and 0.4 mark. Failure to do that could result in dosing slightly higher than expected.</p></blockquote><p></p>
[QUOTE="Re-Ride, post: 65278, member: 8395"] 3 cc pre-fitted with a short needle are common. Uptake the hCG, remove and discard the needle, draw the plunger back so you have 1cc or better air space then set in a vial luer lok side up. Use your insulin needle to draw your AAS and top load it in the 3 cc. Inject with needle of choice, preferable 27G or 25G. The hCG acts as a flush limiting injection loss of the AAS. Injecting with a luer lok needle finer than a 27 is certainly possible but requires excessive plunger pressure. Most doing this prefer deep IM to SQ. There are good reasons not to mix oil and water based injectables including the possible formation of white goo at temps below about 70F and concern about what may happen inside the muscle. One thing to note is how much AAS you are actually drawing and transferring to the injection syringe as there will be nothing left in the drawing syringe if you purge it with air. Use a 0.5 short insulin syringe to draw AAS. Pull the plunger down and measure what you've drawn between the 0.2 and 0.4 mark. Failure to do that could result in dosing slightly higher than expected. [/QUOTE]
Insert quotes…
Verification
Post reply
Share this page
Facebook
Twitter
Reddit
Pinterest
Tumblr
WhatsApp
Email
Share
Link
Sponsors
Forums
Testosterone Replacement, Low T, HCG, & Beyond
Testosterone Basics & Questions
Injecting Testosterone and HCG in same syringe
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top